newdevs:git:install
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| newdevs:git:install [2022/11/23 13:01] – adding in more information for Git set up gmonti | newdevs:git:install [2023/12/13 15:03] (current) – tmccanna | ||
|---|---|---|---|
| Line 61: | Line 61: | ||
| * On the Advanced tab, click Environment Variables | * On the Advanced tab, click Environment Variables | ||
| - In the System variables section, select the Path variable and click Edit. | - In the System variables section, select the Path variable and click Edit. | ||
| - | - At the end of the existing Path variable, type a semicolon and then enter the Notepad++ file path (found above). | + | - At the end of the existing Path variable, type a semicolon and then enter the Notepad++ file path (found above). |
| - Verify that Git Bash recognizes the new command. | - Verify that Git Bash recognizes the new command. | ||
| - Open Git Bash. | - Open Git Bash. | ||
| Line 85: | Line 85: | ||
| ==== 4. Clone the Evergreen Repository ==== | ==== 4. Clone the Evergreen Repository ==== | ||
| + | |||
| + | //Note that these steps assume you have read-only access to origin and write access to working.// | ||
| - Create a folder to store your repositories / branches (for example, C: | - Create a folder to store your repositories / branches (for example, C: | ||
newdevs/git/install.1669226495.txt.gz · Last modified: 2022/11/23 13:01 by gmonti